Carbide burrs are tools utilized for deburring most hard materials like ceramics, stone, steel, aluminum, plastics and hardwood. They offer precision, and will be used in cutting, shaping, grinding and chamfering hard materials.
Carbide burrs works extremely well on the various materials like metals (including Steel aluminum and certain) and all sorts of forms of wood. You can use it on acrylics, fiberglass and plastics too. Carbide burrs will last for a very long time without chipping or breaking to ensure that it’s so great to use them on soft metals like gold,platinum and silver.
Do you know the Attributes of Carbide Burrs In comparison with HSS Burrs?
In contrast to HSS, Carbide Burrs are much harder.
The Tungsten Carbide is extremely hard so that they can provide in wider range of work than HSS (Very fast Steel).
HSS can’t be as good as carbide burrs if they are at high temperature. Carbide Burrs can bear hotness which enable it to run longer time.
Carbide won’t soften at temperature but HSS burrs is opposite. There’s no question that carbide is the perfect choice.
Using Carbide Burs:
To get more stability, insert the accessory bit in to the tool and then back it out slightly before tightening on the collet nut or keyless chuck.
Avoid using these for drilling holes or enlarging holes which are less than twice the diameter in the cutter. The tungsten carbide surface can readily catch along side it of an hole and break the part.
Use higher speeds for hardwoods, slower speeds for metals and slow speeds for plastics (to stop melting at contact point).
Start at the lower speed. Then increase on the speed that provides essentially the most favourable results.
Usually do not apply excessive pressure. It may slow down the spindle and chip cutting edges. Just let the bur perform cutting.
Utilize sides from the cutter for effective cutting. The top cuts poorly which enable it to break under time limits.
Never in-capsulate the bur in the cut. If chattering occurs, increase speed.
When using aluminium and magnesium, consider some kind of lubricant, wax or tallow, since it will help avoid the flutes from loading or packing.
Carbide burs, if used the correct way, will outperform HSS burs by 50
For more details about SD-51 Carbide Burrs just go to this popular web page