Plug and Chain, Click Clack or Appear Waste
You’ll find three basic forms of waste kit. The standard plug and chain waste is known to everyone. A retainer plug and chain waste is a where the plug is inserted to the overflow grill it uses very little to keep it out of how. Plug and chain wastes usually feature the ball chain or possibly a link chain. Most plug and chain wastes will fit most freestanding baths. A click clack waste is a having a sprung plug which operates like many contemporary basin wastes, you push the turn on also it clicks shut, push it again to click it open, with click clack wastes a chrome cover fits on the overflow hole but stands slightly proud of it in an attempt to not block it. A pop-up waste is a that is controlled with a chrome dial that fits on the overflow, a cable runs on the outside of the bath through the dial on the plug and turning the dial causes the cable to maneuver and operate the plug. Most click clack and pop-up waste sold in major chains will not likely fit most traditional freestanding roll top baths.

Concealed or Exposed Waste Kit
A low profile waste kit is a which can be assumed to be fitted in circumstances where solely those parts which are fitted within the bath is going to be seen, so that all of the pipe work on the outside the tub – the overflow pipe, trap and outlet pipe may be plastic. An exposed waste kit is all metal/chrome without plastic parts and is all made to be observed. A conventional double ended freestanding bath if placed approximately against a wall may be fitted having a concealed waste kit since the pipework is going to be hidden between the bath and also the wall. A single ended traditional freestanding bath will often have all the pipework visible when viewed in profile wherever you install it so for these and for double ended baths which are from the wall you’d probably most likely fit an exposed waste kit having a chrome trap and outlet pipe.

Thickness of Freestanding Baths
Most traditional Freestanding Baths are much thicker than standard panel baths and also this can cause an issue with many waste kits. All waste kits have a very parts that sit on both sides in the plug and overflow holes and fasten together to form a sandwich structure together with the wall in the bath to be the sandwich filling and areas of the waste kit on both sides. For plug and chain wastes the parts in the waste kits generally interact with a threaded bolt as a way long because bolts are of sufficient length (that they can are often) then these kits will fit on any thickness of overflow or plug hole. However most click clack and pop-up wastes use rather than bolt a broad bore plastic threaded tube that could be only 7 to 12 mm thick, this is not hick enough for many traditional roll top baths.

Fitting a Trap to some Freestanding Bath
Freestanding baths either with or without feet often have reduced clearance within the bath as well as a standard size bath trap may not fit between the bath and also the floor. If you can to get in the bottom within the bath then a hole can be achieved from the floor for that trap to adjust to into, if however your floor is concrete or of for aesthetic reasons you cannot enter in the floor you will require a shallow or ultra shallow bath trap which you may should get from your specialist.
For more info about Freestanding Baths go our new webpage: read